#Diverter tub spout how to
#Diverter tub spout install

Gently remove it, being careful not to mar the finish.

Remove the cap and handle as in the single handle guide.

Swapping out your faulty diverter valve is the easiest way to address this issue. Your wall diverter is usually the third handle in a three-handle valve.

Wrap Teflon tape around the base of your stem and screw it into place.

Use pliers or a deep-socket wrench to gently turn the stem counterclockwise.

You can fix temperature stem issues the same way you would a two-handle faucet.

Cost: $3.00 to $27.00 depending on manufacturer of replacement parts.

Time: 15 minutes to 1 hour depending on experience.

Three-handle faucets have temperature stems (hot and cold handles) and diverter stems.

Put the bonnet nut and handles back on the unit.

If you’re installing a new stem, throw the old one away and screw in your replacement.

Screw in your new stem and add the handle hardware back in place.

Be sure to coat the new O-ring in petroleum jelly.

Find the O-ring and swap it out with a new one as well.

Be sure the replacement washer is an exact match and coated with petroleum jelly.

#Diverter tub spout install

Remove the screw at the end of the stem and install a new washer.Use pliers to gently turn the stem counterclockwise.You can buy a puller at your local hardware store for between $9 and $15. Pry away the index cap at the front of the handle to access the handle screw.Optional- Handle puller and/or shower valve socket wrench.Cost: $1.00 to $3.00 depending on faucet manufacturer.Time: 20 minutes to 1 hour depending on experience.Installing a new stem is the easiest way to fix a malfunction, but you can an also replace faulty hardware like seals and O-rings. O-ring kits cost around $1.00.Ĭommon in two-handle faucets, stems are mechanisms that use threaded handles and rubber seals to open and close water lines.

Note: Replacing your cartridge’s O-rings can sometimes help. Turn the water back on to make sure your faucet doesn’t leak.

Replace the retaining clip and reassemble your faucet.

Cartridges are specific to faucet make a model.

Take the old cartridge to the hardware store to ensure you get the right replacement.

You may have to buy a cartridge removal tool if it’s stuck. Some manufacturers provide a cap that threads onto the valve to aid in removal.

Remove the cartridge by gently pulling with pliers.

Use a screwdriver to remove the retainer clip at the top of the cartridge housing.

Locate the set screw under the handle or cap at the front of the unit.

Optional- Handle puller and/or cartridge puller (may require an adjustable wrench).

Replacement is the easiest way to fix cartridge-related problems.

When the water flow is steady, you’re done.Ĭommonly found in single-handle faucets, valve cartridges are cylindrical devices that use O-rings to control the flow of water. When you turn the water back on, turn on all of your taps to force out any air that may have gotten in. Then turn on the shower and let the pipes drain out. If you can’t find the valve that turns off the shower, turn off the water to the entire house (should be in basement or outside). Important note: Be sure to turn off the water before you begin.

#Diverter tub spout how to

How to Replace or Install Valves by Faucet Type

Steps to Replace/ Install Faucet by Type.

Here’s a look at a variety of solutions for your troublesome faucet or valve. Replacing or repairing a faucet isn’t difficult, but the process will vary based on your plumbing and the nature of the issue. In many cases, faucet problems stem from one of these components. Your faucet uses a system of valves and handles to control the temperature and flow of water in your bathtub or shower.